Low friction low friction, excellent wear properties and high mechanical strength. Lubramid® 600 T is molded nylon (PA6 G), which contains special additives and lubricants. The careful selection of lubricants and their coordinated composition has a continuously focus on the sliding properties made it possible to produce a synthetic material with an extraordinary low friction, which is down to 0.15 μ. Furthermore, the presence of the unwanted stick-slip effect reduced to an absolute minimum.
Lifelong self-lubricating effect. Lubramid® 600 T has a lubricating effect and good sliding properties, which remain stable throughout the life of the product. To this is added the high wear resistance of the base plastic of PA 6 G, which also leads to the well-known good and uncomplicated machining of the product.
Lubramid® 600 T is probably the best product when the sliding properties of HDPE 1000 is desired and at the same time requiring a high abrasion and mechanical strength. Lubramid® 600 T is also where the lubrication of machine parts is difficult, impossible or undesirable. Many products that have so far been made of molded nylon (PA 6 G), can be replaced by a Lubramid® 600 T. This provides longer life and less wear with less cost.
- Plain Bearings
Lubramid® 600 T available as semi-finished products in the form of plates, rods and hollow bars. Gray is the default color in stock. Nature, red and green, where nature is food approved, can be obtained from work.
|Lubramid® – Moist||Lubramid® – Dry|
|Ball pressure hardness, MPa||125||160|
|Tensile strength, MPa||60||80|
|Modules of elasticity, MPa||2000||3300|
|Moisture absorption 50%RF, %||n/a||2,2/6,5|
|Application temperature, 0C||n/a||-40/+105|
|Coefficient of expansion, 10-5/0C||n/a||7,5|
+ = useful / – = non useful / () = limited useful